National Electrical Code (NEC) Fundamentals
$20.002 PDH — Mechanical / Electrical Engineering
Showing 65–80 of 95 results
-
-
-
Painting and Corrosion Protection of Hydraulic Structures (USACE)
$20.002 PDH — Mechanical / Electrical Engineering
-
-
Planning and Design of Hydroelectric Power Plant Structures (USACE)
$20.002 PDH — Mechanical / Electrical Engineering
-
-
Power Quality and Harmonics
$20.00A 2-PDH course ending in a 10-question assessment (70% to pass). Educational overview of consensus-standard practice; confirm CE acceptance with your board.
-
Pressure Vessel Design and Safety (ASME)
$20.00A 2-PDH course on pressure vessel design and safety fundamentals grounded in ASME Boiler and Pressure Vessel Code Section VIII.
-
Pressure Vessel Design to ASME BPVC Section VIII
$20.00A 2-PDH course on pressure vessel design to ASME BPVC Section VIII Division 1, covering design conditions, shell and head thickness, nozzles, and inspection.
-
Protective Relaying and Coordination Studies
$20.00A 2-PDH course on protective relaying and coordination studies, covering relay principles, protection zones, coordination, and IEEE standards for power systems.
-
Psychrometrics and Air-Handling Process Calculations
$20.00A 2-PDH course on psychrometrics and air-handling process calculations, covering moist air properties, the psychrometric chart, and common airside equations.
-
Pump Selection, Sizing, and Variable-Speed Pumping
$20.00A 2-PDH course on centrifugal pump selection and sizing covering system curves, best efficiency point, NPSH available versus required, cavitation, the affinity laws, and variable-speed pumping per Hydraulic Institute practice.
-
Pump Selection, System Curves, and Cavitation (NPSH)
$20.00A 2-PDH course on centrifugal pump selection, system curves, affinity laws, and cavitation prevention through net positive suction head analysis.
-
Refrigeration Cycles and System Design
$20.00A 2-PDH course on refrigeration cycles and system design, covering the vapor-compression cycle, its four components, superheat and subcooling, COP, and refrigerant selection.
-
-
Shaft Design: Torsion, Bending, and Fatigue
$20.00A 2-PDH course on shaft design covering torsion, bending, combined loading, stress concentrations, and fatigue-based sizing using ASME and machine-design methods.
